page 1 AS 2001- Allpro ORIGINAL INSTRUCTIONS Read the installation and operating instructions carefully before using
page 10 Dressing of the grinding wheel 1. When dressing the grinding wheel always adjust the grinding wheel sideways to position 3.0 mm. See Pict
page 11 Grinding. 1. Check the desired hollow radius and adjust if needed. Referring to the dressing of the grinding wheel. (Page 9.) 2. Adjust
page 12 b. Use a flat template to set a correct height on the heel of the blade so that the grinding wheel will not make the heel rounded. Then by
page 13 8. Important! If you wish to reset the grinding push quickly 2 times the “SHARP” button when the skate-holder is going from lef
page 14 rotates over the whole template the skate has been profiled from the whole 7. Radius profiling. Choose a radius template and put the tem
page 15 Change of the grinding wheel Changing of the wheel and all service work may only be done when the main power is switched off. But before sw
page 2 Installation instructions 1. Unpacking and installation: Open the transportation box by unscrewing the locks on both sides of the transport
page 3 4. Guard against electric shock. Avoid body contact with earthed or grounded surfaces (e.g. pipes, radiators, ranges, refrigerators) 5. K
page 4 Control Panel Manual
page 5 Designation ProSharp AS 2001-Allpro is a skate sharpening machine and should be used only to sharpen ice skates. Safety Information and R
page 6 = Never lay your hands on the machine when the sharpening procedure is on! Connection Connect tab single-phase A.C, 100-240 VAC 50-60
page 7 The ProSharp AS 2001- Allpro delivery includes: 1 Skate Sharpening Machine ProSharp AS 2001- Allpro 1 Grinding wheel MA70 1 Dressi
page 8 FINLAND T. +358 40 5309 392 E. [email protected] Change of the grinding wheel and all service work may only be done when the main power is
page 9 Test run without grinding until there is no slippage. After 3000-5000 pairs: Service should be made by an authorized service technician.
Comments to this Manuals